Assembly - Partner K 650/700 Active Workshop Manual

1
C
8
Starter unit

Assembly

Mod. 650, 700, 950
Clean the starter unit components and fit
the spring cassette.
Anchor the cord in the pulley.
Push the pulley on the shaft stem.
B
Anchor the starter cord in the starter
handle with a double knot.
Assembly
Mod. 650, 700, 950
Clean the different starter unit parts.
Lubricate the return spring with oil and
place the spring cassette in the starter
unit housing.
Make sure that the spring end is not
clenched.
Tighten the screws.
Anchor the cord round the pulley hub as
shown in the illustration.
Push the cord down on the shaft journal in
the starter unit housing.
Make sure that the return spring grips in
the pulley.
Lubricate the starter housing stem and
pulley with a few drops of oil.
Fit the other parts in the pulley hub.
NOTE!
Turn the metal sleeve (B) correctly.
Check that the O-ring (C) is undamaged.
Lubricate it with a few drops of oil.
Tighten the centre screw and check that
the pulley can turn freely.
Enter the cord through the cord guide in
the starter unit and anchor it in the starter
handle with a double knot.