Replacing The Starter Cord Without Dismantling The Pulley - Partner K 650/700 Active Workshop Manual

Starter unit
Allow the pulley to slowly rotate back-
wards.
Remove the starter handle.
Mod. 950, 1250
Remove the screws which hold the star-
ter unit, and lift off the starter unit.
The next stage in the dismantling work
follows mod. 650/700.
Replacing the starter
cord without dismant-
ling the pulley
Mod. 650, 700, 950, 1250
Remove any remaining rope from the
pulley and check that the return spring
recoils.
Insert the new starter rope through the
hole in the pulley.
K650/700
K950
Allow the pulley to slowly rotate back-
wards.
NOTE!
Brake the rotation with the thumb.
Untie the knot on the starter rope and
remove the starter handle.
Tips!
The knot may be difficult to untie. It is
easier if it first is tapped with a hammer
while placed on a hard surface.
Mod. 950, 1250
Remove the screws which hold the star-
ter unit, and lift off the starter unit.
NOTE!
The air filter and cylinder covers do not
need to be dismantled.
The next stage in the dismantling work
follows mod. 650/700.
Replacing the starter
cord without dismant-
ling the pulley
Mod. 650, 700, 950, 1250
Remove any remaining rope from the
pulley.
Check that the return spring and its
attachment in the pulley has not been
damaged by turning the pulley clockwise.
Enter the new starter rope through the
hole in the pulley as shown in the illustra-
tion.
Anchor the rope round the hub on the
K1250
pulley as shown in the illustration.
Pull the rope tight and make sure that the
free end is as short as possible.
Cord lengths
Models 650, 700, 950: 1150 mm.
Models 1250: 1250 mm.
These lengths apply to Ø 4 mm cord.
1
5