Partner K 650/700 Active Workshop Manual page 83

7
A.
B.
C.
E.
82
Cutting equipment
D.
Place a new drive belt round the clutch
drum and it the clutch cover.
Inspect the drive belt for wear and damage
before it is fitted.
Fig. A. Normal condition of a belt after
prolonged use.
Fig. B. Replace the belt if after a short
period of use it shows signs of
cracking across the belt, even if
there is only slight wear on the
sides.
Fig. C. Worn, rough edges on the belt
are the result of incorrect contact
with the pulley or loose nuts on
the cutter arm.
Fig. D. Irregular wear resulting from loose
belt or high idling speed.
Fig. E. Worn off strips of belt, worn
reinforcement, resulting from poor
contact, oil on the pulley, or
incorrect belt quality. Use Partner
Genuine Belts.
Place a new drive belt round the clutch
drum.
Ffit the clutch cover. Do not forget the
screw in the lower edge of the guard.