Partner K 650/700 Active Workshop Manual page 50

Cylinder and piston
A
B
Mod. 950
Dismantle all components so that the
cylinder becomes accessible.
Dismantle the carburettor and screws
that hold the spacing piece to the crank-
case.
502 50 18-01
Remove the screw which holds the vibra-
tion damper to the grip.
Dismantle the damper from the cylinder.
502 50 18-01
Unscrew the cylinder screws and lift off
the cylinder
Dismantle the intake pipe and impulse
hose. If there are signs of cracking replace
with new parts.
502 50 64-01
Mod. 1250
Dismantle all the necessary parts to gain
access to the cylinder, including the cutting
equipment.
502 50 18-01
501 69 17-02
Mod. 950
Dismantle all components so that the
cylinder becomes accessible.
Remove the start valve, blue centrifugal
nozzle and muffler.
Note the nut in the nut recess on the
crankcase at the lower muffler screws,
and make sure it is not dropped.
Dismantle the carburettor and the two
screws that hold the spacing piece to the
crankcase.
Remove the screw which holds the vibra-
tion damper to the grip.
Insert key 502 50 18-01 in the centre of
the vibration damper and unscrew the
screw which holds the damper to the
cylinder.
Unscrew the cylinder screws with key
502 50 64-01.
Lift the cylinder straight up and place a
clean cloth in the crankcase opening to
prevent dirt from dropping down into the
crankcase.
Dismantle the intake pipe and impulse
hose.
Inspect the parts and replace them if they
show signs of cracking.
Mod. 1250
Dismantle all the necessary parts to gain
access to the cylinder.
Use the universal tool 501 69 17-02 to
dismantle the start valve.
All the cutting equipment must be
dismantled in order to be able to dismantle
the muffler.
Dismantle the cutter arm attachment by
removing the nut (A) and the screws (B)
with key 502 50 18-01.
5
49