Partner K 650/700 Active Workshop Manual page 75

6
74
Model 950 – Crankcase lubrication hole
Remove the centrifugal clutch and seal the lubrication hole with tape.
Model 1250 – Muffler side
Remove all the cutting equipment, including the rear cutting arm.
Remove the muffler and heat shield plate.
Install cover washer No. 502 71 39-01 over the exhaust port. Use the muffler
attachment screws and nuts, together with two spacer sleeves No. 502 71 40-01.
502 71 39-01
Model 1250 – Carburettor side
Remove the carburettor.
Remove the spacer from the cylinder.
NOTE!
Do not force off the plastic component which guides the throttle cable. Insert Allen key
No. 502 50 18-01 through the tapped holes and undo the screws which hold the spacer
to the cylinder.
502 50 18-01
Fold the spacer to one side, hanging from the throttle cable.
Fix seal washer No. 502 71 38-01 with two M5x15 mm screws.
502 71 38-01
502 71 40-01