Replacing The Spark Plug Protection; Dismantling - Partner K 650/700 Active Workshop Manual

Ignition system
Adjust the air gap.
502 51 34-06
Replacing spark plug
protection
1. Take the ignition cable through the
plug protection.
2. Fit the contact spiral on the ignition
cable.

Dismantling

Mod. 650, 700
Dismantle the cylinder cover, plug, star-
ter unit, and air conductor.
Dismantle the ignition module and re-
lease the other cable connections.
K 950
Adjust where appropriate the air gap to
the correct distance.
• Release the screws holding the
ignition module.
• Position the feeler gauge on the
magnets of the flywheel and press the
ignition module against flywheel.
• Tighten the screws and check the air
gap again.
If there is still no spark then the ignition
system should be replaced.
Replacing spark plug
protection
1. Grease the ignition cable with a little
grease and take it through the plug
protection.
2. Cut off a piece of the ignition cable
(approx. 5 mm, 3/16") to obtain full
contact with the spark plug protection.
3. Fit the contact spiral on the ignition
cable and make sure that the wire is
folded along the cable.
4. Pull the contact spiral in the plug
protection.
NOTE!
It is important that the point on the contact
spiral meets the middle of the ignition
cable to prevent sparking.
Dismantling
Mod. 650, 700
Dismantle the plug, cylinder cover, star-
ter unit, and air conductor.
Dismantle the ignition module by remo-
ving the two screws.
Release the other cable connections and
lift off the ignition module.
Mod. 950, 1250
K 1250
Dismantle the starter unit, air filter cover,
air filter and cylinder cover.
Remove the air conductor.
Note the position of the cables so that
they can be replaced in the same way.
2
15