Partner K 650/700 Active Workshop Manual page 17

2
16
Ignition system
Fit piston stop No. 502 54 15-01 in the
spark plug hole.
502 54 15-01
Mod. 650, 700, 950, 1250
Dismantle the starter pawls.
Remove the flywheel nut.
Pull off the flywheel.
502 51 49-02
Insert piston stop No. 502 54 15-01 in the
sparking plug hole.
Make sure that the piston stop does not
come out through the exhaust port, it
must rest against the front of the cylinder
wall when the piston approaches Top
Dead Centre.
Mod. 650, 700, 950, 1250
Dismantle the starter pawls by releasing
the screws. Make sure the small washer
which lies next to the flywheel is not lost.
Remove the flywheel nut by means of a
suitable box spanner.
Remove the flywheel by means of fly-
wheel puller 502 51 49-02, which is
screwed tight in the holes for the pawls.
NOTE!
Centre the flywheel puller over the shaft
centre. Select suitable screws and tighten
the withdrawing tool.