Vibration Dampers - Partner K 650/700 Active Workshop Manual

6
A
B
62
Crankshaft and crankcase
Mod. 950
Pull off the seal with an extractor.
502 50 55-01
Lubricate the shaft with a few drops of oil
and fit a new seal.
Fit the other parts in the reverse order to
dismantling.
502 50 82-01

Vibration dampers

Mod. 650, 700
Remove the screws and separate the
grip from the attachment in the crankcase.
Remove the damper.
Assembly is conducted in reverse order
to dismantling.
505 38 13-08
The vibration damper at the cylinder can
be dismantled for replacement after the
screws (A) and (B) have been dismantled.
505 38 13-08
Mod. 950
Dismantle all parts on the clutch side so
that the seal becomes accessible.
Screw in the seal extractor as far as it
goes in the seal, and pull off the seal.
Lubricate the shaft with a few drops of oil
and fit a new seal in place with the plate
cover turned outwards.
Press the seal in the crankcase with a
suitable drift until it is flush with the
crankcase.
Check that the hole in the crankshaft for
lubrication of the clutch bearing is not
blocked. If so, clean with compressed air.
Fit the other parts in the reverse order to
dismantling.
NOTE!
Remember the spacer sleeve between
the clutch drum and crankcase.
Vibration dampers
Mod. 650, 700
Remove the two screws (A) and separate
the grip from the attachment in the
crankcase.
Remove the damper (B). It may have to
be rotated to aid removal.
Fit a new damper in the reverse order to
dismantling.
The vibration damper at the cylinder can
be dismantled for replacement after the
screws (A) and (B) have been dismantled.