Partner K 650/700 Active Workshop Manual page 85

7
84
Cutting equipment
Fit the cutter arm
Tension as the drive belt at the same time
as the cutting disc is rotated, and tighten
the two nuts.
Lift the cutter arm in place.
Fit the drive belt over the front pulley.
Push the front belt cover in place and
screw down the attachment screws half
way.
Tension the drive belt in the same way as
for mod. 650, and 700, and then tighten
the two screws.
TIP!
Install a diamond cutting disc and warm
the circular saw up for about 2 minutes.
Check the belt tension and re-tension the
belt if necessary.