System Settings - Lightware MODEX-OPTS-TX User Manual

Setting the Static gateway
Step 1. Navigate
Step 2. Use left ◄ and right ► buttons to place the cursor to
Step 3. Set the numbers by the up ▲ and down ▼ buttons.
Step 4. Press the enter  button to save changes.
Step 5. Press the enter  button to restart device
DHCP setting
Step 1. Navigate to Settings / Network Settings / DHCP
Step 2. Use the up ▲ and down ▼ buttons to toggle between
Step 3. Press the enter  button to save changes.
Step 4. Press the enter  button to restart device
Renew the IP address
Step 1. Navigate to Settings / Network Settings / Renew IP
Step 2. Press the enter  button to confirm.

5.3.2. System settings

Resetting the device
Step 1. Navigate to Settings / Reset submenu and press the
Step 2. Press the enter  button to restart device or the
Step 3. The extender is immediately restarted.
Enter bootload mode
Firmware upgrade of the device can be executed only in Bootload mode. If the working
mode of the device is not switched to bootload mode automatically, the mode can be also
switched manually.
Step 1. Navigate to Settings / Enter bootload submenu and
Step 2. Press the enter  button to switch to Bootload mode.
Step 3. LCD will turn to dark. (The device can be switched to
Loading factory defaults
Step 1. Navigate to Settings / Fact. defaults submenu and
Step 2. Press the enter  button to load factory defaults or
Step 3. The device is restarted; factory default settings and
Section 5. Front panel operations
to Settings
Static gateway submenu, press the enter  button.
the desired number.
(recommended).
submenu and press the enter  button.
Enabled and Disabled settings.
(recommended).
submenu and press the enter  or the right ► button.
enter  button.
escape button to cancel.
●
press the enter  button.
normal operation mode by pressing the reset button
or turning it off and on again.)
press the enter  button.
the escape button to cancel.
●
parameters are set. See the list about the details in section
MODEX-OPTS, MODEX-OPTM
/ Network Settings
User's Manual
¹Network SettinÞ
/
¾-Static gatewº
¹Static gatewayÞ
192.168.000.0½
Restart now?
ENTER=Yes ESC=No
¹Network SettinÞ
¿-DHCP
¹DHCP:
Disabled
Restart now?
ENTER=Yes ESC=No
¹Network SettinÞ
¿-Renew IP
Renew IP?
Enter=YES ESC=NO
¹System
¾-Reset
Restart Device?
ENTER=Yes ESC=No
¹System
¾-Enter bootloº
Enter Bootload?
ENTER=Yes ESC=No
----------------
¹System
¿-Fact. defaulº
Fact. defaults?
ENTER=Yes ESC=No
11.2 on page 111.
Page 31 / 113
º
Þ
½
º
º