MIMAKI JV150-130 Operation Manual page 94

Chapter5 Troubleshooting
Message
ERROR 423
TAKE-UP TENSION-BAR
ERROR 425
Take-UP WRONG
ERROR 429
Take-UP LimitDETECT
ERROR 44f
Take-UP Roll Sns Err
ERROR 505
MEDIA JAM
ERROR 509
HDC POSCNT
ERROR 50a
Y ORIGIN
ERROR 50f
L-SCALE BLACK
ERROR 529
LEnc.Count HPC[____]
ERROR 52a
LEnc.Count HDC[____]
ERROR 52c
MEDIA WIDTH SENSOR
ERROR 516
MEDIA SET POSITION R
ERROR 528
PUMP MOTOR SENSOR
ERROR 602
CARTRIDGE END
ERROR 608
WRONG INK IC
5-10
Cause
Error in the option tension bar.
• The tension bar origin could not be
found.
• No change could be seen in the ten-
sion bar angle.
A problem has occurred in the option
tension bar.
• The tension bar control position has
deviated from the lowest point for a
certain period.
LIMIT position of the tension bar has
been detected.
• The tension bar control position has
deviated from the highest point for a
certain period.
Roller sensor abnormality
• The roller sensor cannot be correctly
read.
The media jam occurs.
An error occurred in the control position.
Y-origin could not be detected.
Abnormal linear scale.
The media width could not be correctly
read.
The media is set outside the proper
area.
Pump sensor detection error
Ink end (cannot be used, can only be
used when cleaning with the 4-color ink
set)
The ink cartridge IC chip cannot be cor-
rectly read.
Solution
• Check the set state of the media.
• Make sure that the media can be wound
using the manual SW. Also, make sure that
the tension bar rises.
If it does not rise, adjust the counterweight
while referring to the user manual attached
to the AMF kit.
• Confirm that the winding unit of machine set-
ting and tension bar setting are ON.
• Check the set state of the media.
• Confirm that the winding unit operates using
the manual SW.
• Remove the media and reset it.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Check the media set position. (
• Clean the media sensor. (
• Turn the main power OFF, wait a while, and
then turn it ON again.
• Check the media set position. (
• Turn the main power OFF, wait a while, and
then turn it ON again.If the same error mes-
sage appears, contact our service desk or
your local distributor to call for service.
• Replace with new ink.
• Make sure that the cartridge is correctly
inserted.
• Reinsert the cartridge.
• Turn the main power OFF, wait a while, and
then turn it ON again.If the same error mes-
sage appears, contact our service desk or
your local distributor to call for service.
P.2-4)
P.4-3)
P.2-5)