MIMAKI JV150-130 Operation Manual page 93

Message
ERROR 18c
Main PCB V12
ERROR 190
Main PCB V42-1
ERROR 192
COMIO PCB V1R2
ERROR 193
COMIO PCB V2R5
ERROR 194
COMIO PCB V3R3
ERROR 195
COMIO PCB V24
ERROR 1a0
SLDR2H PCB V1R2
ERROR 1a6
SLDR2H PCB V2R5
ERROR 1a7
SLDR2H PCB V3R3
ERROR 1a8
SLDR2H PCB V5
ERROR 1a9
SLDR2H PCB V42
ERROR 201
COMMAND ERROR
ERROR 202
PARAMETER ERROR
ERROR 304
USB INIT ERR
ERROR 305
USB TIME OUT
ERROR 401
MOTOR X
ERROR 402
MOTOR Y
ERROR 403
X CURRENT
ERROR 404
Y CURRENT
Cause
An error occurred in the main PCB .
An error occurred in the COM16/32IO
PCB .
An error occurred in the SLIDER2H PCB
.
The machine received some data other
than print data.
Or, an error occurred in the transmitted
print data.
An error occurred in the transmitted print
data.
An error occurred in the communication
of USB.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
An error due to an excessive current of
the X motor was detected.
An error due to an excessive current of
the Y motor was detected.
Chapter5 Troubleshooting
Solution
• Turn off the power to the machine and turn it
on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Securely connect the interface cable in posi-
tion.
• Use an interface cable conforming to the
specifications.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
1
2
2
2
5
6
5-9