MIMAKI JV150-130 Operation Manual page 82

Chapter 4 Maintenance
Replace the waste ink tank with
another
1
The warning message "Check waste ink"
is displayed.
2
Press the
3
Check the state of the waste ink tank.
4
If the amount of waste ink needs to be
adjusted, press the
• Compare the amount of waste ink shown on the
display and the amount you visually confirmed. If
there is no major problem with the value shown
on the display, instead of the [ENTER] key, press
the [END] key and proceed to Step 6.
5
Press
press the
6
Pull the waste ink tank stopper to open to
the front.
Waste ink tank
stopper
7
Pull it frontward to remove by holding the
waste ink tank handle.
• Put a cap on the waste
ink tank removed.
4-16
(MAINT.) key.
key.
to adjust the level, and
key.
Waste ink
tank
Cap
8
Replace the waste ink tank.
(1) Prepare a new waste ink tank (SPC-0117).
(2) Insert the waste ink tank by holding a handle
of the tank.
New waste ink
tank
• Waste ink is equivalent to waste oil of industrial
waste. Request an industrial waste disposal
company for disposal of waste ink.
9
Close the waste ink tank stopper.
10
Press the
• The ink discharging amount that is controlled by
the machine is reset and the message is
cancelled.
key.