Setting Event Mail Function - MIMAKI JV150-130 Operation Manual

Chapter 3 Mchine setting
12
Press the
• The setting items DEFAULT GATEWAY, DNS
ADDRESS and SUBNET MASK will be displayed.
• Both of DHCP and AutoIP is OFF, you can set
DEFAULT GATEWAY/ DNS ADDRESS/ SUBNET
MASK. For other than above, proceed to the Step
14.
13
Press the
setting item, and press the
14
Press
press the
15
Press the
to end the setting.
• To reflect network setting, once turn off the power
supply and then turn it on again.
3-18
key .
several times to select
key.
to select a set value, and
key.
key several times

Setting event mail function

Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://eng.mimaki.co.jp/download/).
• Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
Enable the event mail function
1
Press the
times)
• MACHINE SETUP MENU will be displayed.
2
Press the
3
Press
and press the
4
Press the
• "MAIL DELIVERY" will be selected.
5
Press
press the
6
Press the
to end the setting.
(MENU) (twice
key in LOCAL.
(>>) .
to select "EVENT MAIL",
key.
key.
to select "ON", and
key.
key several times