Safety Interlock - MIMAKI JV150-130 Operation Manual

Warning
• Be sure to thoroughly consume the ink in the ink cartridge, once
it is opened, within three months. If an extended period of time
has passed away after opening the cartridge tank, printing
quality would be poor.
• Neither pound the cartridge nor shake it violently, as doing so
can cause leakage of ink.
• Do not touch or stain the contacts of the ink cartridge, as doing
so may cause damage to the print circuit board.
• Consult your sales or service representative for proper disposal
of ink cartridge, ink pack, and waste ink.
When you dispose them by yourself, follow the regulations
stipulated by the industrial waste disposer or the country or
region you live in
Handling of media
• Use media recommended by MIMAKI to ensure reliable, high-
quality printing.
• Set the heater temperature to meet the characteristics of the
media. (Model with a built-in heater)
Set the temperature of the Pre-heater, Print heater and Post-
heater according to the type and characteristics of the media
used. Automatic temperature setting can be made on the
operation panel by setting the profile on the dedicated RIP. For
setting on the RIP, refer to the instruction manual for your RIP.
• Pay attention to the expansion and contraction of the media.
Do not use media immediately after unpacking. The media can
be affected by the room temperature and humidity, and thus it
may expand and contract.The media have to be left in the
atmosphere in which they are to be used for 30 minutes or more
after unpacked.
• Do not use curled media.
The use of curled media can not only cause a media jam but
also affect print quality.
Straighten the sheet of media, if significantly curled, before
using it for printing. If a regular-sized coated sheet of media is
rolled and stored, the coated side has to face outside.
• Do not leave the media with the heater ON for a long time.
Notes on maintenance
• It is strongly recommended to use the machine in a room that is
not dusty.
• Keep the front cover closed even when the machine is not
printing. If not, dust can accumulate on the nozzles in the heads.
• Dust in the heads can also cause drops of ink to fall suddenly
down on the media during printing. In such a case, be sure to
clean up the heads. ( P.4-11)
• When cleaning the ink-station or the heads, make sure to wear
the attached gloves. Further, when the solvent ink is used, it is
necessary to wear the attached goggles.
• Perform wiping (removal of dust and paper powder) of the
capping station and wiper frequently.
Cautions on Installation
CAUTION
A place exposed to direct
sunlight
A place that vibrates
A place where temperature or
humidity varies significantly
• Use the machine under the
following environmental
conditions:
• Operating environment:
20 to 30 °C
(68 to 86 °F)
35 to 65 % (Rh)

Safety interlock

This machine is equipped with interlocks to terminate the
operation for your safety when the cover opens during
printing etc. (red circle parts in the figure below).
Safety Precautions
On an inclined surface
A place exposed to direct air
flow from an air conditioner
or the like.
Around a place where fire
is used
1
2
3
4
5
6
viii