System Halt - MIMAKI JV150-130 Operation Manual

Message
ERROR 612
INK LVL LOW
ERROR 613
INK LVL END
ERROR 614
Preservation Failure
ERROR 627
RE-INSERT CARTRIDGE
ERROR 628
WRONG INK CARTRIDGE
ERROR 63c
INK REMAIN ZERO
ERROR 702
THERMISTOR CONNECT
ERROR 710
HEATER TEMP ERROR
ERROR 901
INVAILD OPERATION
ERROR 902
DATA REMAIN
ERROR 90d
NO HEAD SELECT
ERROR 90f
PRINT AREA SHORT
ERROR 04
PARAM ROM

SYSTEM HALT

Cause
When using a 600cc cartridge, the
remaining ink has dropped to less than
60cc.
When using a 600cc cartridge, the
remaining ink has dropped to less than
25cc.
Writing in IC failed in the 600cc cartridge
use and the weight input.
There is a slot in which the cartridge has
not been inserted more than a certain
time.
A problem has occurred in the ink car-
tridge IC chip information.
The used count has exceeded the pre-
scribed value.
Remaining ink is 0 in the cartridge (ink
end/ only when the 4-color ink set is
used)?
The thermistor connection of a heater is
defective.
The temperature abnormality of the
heater has been detected.
When this error occurred and if the tem-
perature abnormality cannot be
resolved, the power supply of the
machine is forcibly turned off.
Due to a certain error, the function can-
not be performed.
There remains received data that has
not yet been printed.
An error occurred in the mounted heads.
The media width or the media length
required for printing is not enough.
An error occurred in the main PCB
FROM.
Chapter5 Troubleshooting
Solution
• Remove and weigh the 600cc cartridge, then
set it again.
• ( P.3-22 "When [Ink Level low] is displayed")
• Make sure that the cartridge is correctly
inserted.
• Reinsert the cartridge.
• Turn the main power OFF, wait a while, and
then turn it ON again.If the same error mes-
sage appears, contact our service desk or
your local distributor to call for service.
• Set a cartridge.
• Make sure there is no nozzle clogging
(especially for the white ink).
• Replace with new ink.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Return to the local screen, check the error
status and take a countermeasure.
• Execute the data clear function. (
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Change the media to the one with enough
width or length.
• When the media width narrows because the
origin moved, slide the origin to the right to
widen the effective media width.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
1
2
2
P.2-14)
2
5
6
5-11