When The Machine Is Not Used For A Long Time - MIMAKI JV150-130 Operation Manual

When the Machine Is Not Used for a
Long Time
When the machine is not going to be used for a week or
more, use the cleaning function for custody to clean the
head nozzles and ink discharge passage.After this, keep
the machine in custody.
• Use the machine with always turning "ON" the
main power. The function preventing nozzle
clogging operates automatically to protect the
head of the nozzle.
• The head nozzle may result in nozzle clogging if
the main power switch is left OFF for a long time.
Check the items on the right beforehand.
Is [NEAR END] or [INK END] displayed?
• The cleaning solution or ink is absorbed when the nozzles
are washed.
At this time, if the state of "no ink" or "almost no ink" is
detected, the nozzle washing operation cannot start.
• Replace the cartridge with another from which the state of
"almost no ink" or "no ink" is not detected.
• When the worning messages "Check waste ink"
are indicated, check the waste ink tank, and then
operate it, referring to P.4-15 "If a Waste Ink Tank
Confirmation Message Appears" according to the
situation.
1
Press the
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the
• "STATION" will be selected.
3
Press 3 times, and press the
key.
• "CUSTODY WASH" will be selected and the
carriage will move onto the platen.
• Until wiper/ bracket cleaning is competed,
"COMPLETED" is displayed on the screen. After
the work up to the step 3 is completed, press the
[ENTER] key. If you press the [ENTER] key before
cleaning is completed, the machine moves to the
next washing procedure.
(MENU)
key.
4
Clean the wiper and the bracket.
(1) Open the front cover then pull out it by
holding projections at both ends of the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in
maintenance. (SPC-0369) Wipe off so that
cleaning solution for maintenance will not
remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
5
Press the
• Until wiper cleaning is competed, [COMPLETED
(NEXT): ENT] is displayed on the screen. After the
work up to the step 5 is completed, press the
[ENTER] key. If you press the [ENTER] key before
cleaning is completed, the machine moves to the
next washing procedure.
6
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
• Wipe off so that maintenance solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
Cap rubber
Chapter 4 Maintenance
cleaning solution for
Projection
key.
4-9
1
2
2
4
5
6