MIMAKI JV150-130 Operation Manual page 30

Chapter 2 Basic Operation
8
Insert the roll media in this machine.
• The roll media can be smoothly inserted by
slanting the media.
(1) Pull the media out of the roll to the head of
the platen.
(2) Insert the media between the platen and the
pinch roller.
• Pull the media out of the roll so that the
media can be grasped from the front of the
machine.
(3) Push down the clamp lever from the back of
this machine.
• The media is held.
9
Pull out the roll media out.
(1) Open the front cover.
(2) Raise the clamp lever from the front of this
machine.
(3) Pull out the roll media gently and then stop
pulling when locked lightly.
2-6
10
Make the roll media even then lower the
clamp lever.
• Pulling several positions of the media lightly,
Lower the clamp lever after confirming that the
amount of the roll media pulled out is almost
even.
11
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
Media press
• When installing the media, align the media's right
edge with the groove in the platen. Placing the
media rightward of the groove will make it rise up if
it moves obliquely, and this could cause damage
to the head.
• If a media is misaligned to the right/left more than
fixed position, a error message "MEDIA SET
POSITION R" is displayed. Set the media again.
Groove
Media
Media
Press