Chapter 2 Basic Operation
Printing Data
Starting a Printing Operation
• When using a roll media, rewind the media by
hand before printing so that it is not loose.When
the roll media has not been rewound tightly, it may
cause the image quality to deteriorate.
1
Setting a Media (
2
Press the
• The screen changes to REMOTE, and data can
be received from the PC.
3
Transmit data to be printed from the PC.
• The ACTIVE lamp blinks and the printing
conditions are displayed.
• For the method of data transmission, see the
instruction manual for the output software.
Resolution
360 /540 /720 /1440 DPI
Number of passes
Scan direction
The length of media printed
4
Start printing.
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.
2-14
P.2-4)
(REMOTE) key in LOCAL.
Uni : Unidirectional
Bi : Bidirectional
Scanning speed
Std : Standard speed
Hi : Double speed
Data type
Vd : Variable data
Nd : Normal data
Stopping a Printing Operation
Perform the following operation when stopping a printing
operation halfway.
1
Press the
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.
Deleting Received Data (Data Clear)
When you want to stop printing, delete the already
received data.
1
Press the
(DATA CLEAR) in LOCAL.
2
Press the
• The received data is erased then it returns to the
Local.
Cutting a media
By using the keys on the operation panel, you can cut the
media at any position.
1
In Local, Press
• It enters into the origin setting mode.
• By pressing [] , feed the media to the cutting
position.
2
Press the
• The media is cut.
• When the cutting has been completed, the current
mode returns to LOCAL.
(LOCAL) during printing.
key, and press the
key.
.
key.