Christie cp2215 User Manual page 75

3. Complete these fields:
3D Sync Input Mode
L/R Display Reference
Frame Rate N:M
L/R Display Sequence
3D Sync Polarity
Dark Time
Output Delay
Phase Delay
4. Tap Save.
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
Downloaded from ProjectorsManual.com Manuals
Field
Specifies whether a specific frame of input data has left eye or right eye
data.
Select Use White Line Code (true and inverted) if you are using a
single 3D input signal in which an embedded white line at the bottom of
each frame identifies left and right, and an additional separate 3D stereo
sync input at the GPIO port is not present. The bottom row of the left-eye
sub-field should be pure white for the left-most 25% of the pixel row and
pure black for the remainder of the row. The bottom row of the right-eye
sub-field should be pure white for the left-most 75% of the pixel row and
pure black for the remainder of the row.
Select Use Line Interleave for 3D source data only. When specified,
the ICP will de-interleave each line into the left image or right image in
memory as specified. Line interleave can be used with PsF 3D data (left
and right data for one field, then left and right data for second field).
Specifies which frame of eye data to display during a specific display
frame. This signal is referenced to the display frame rate which is
specified by the Frame Rate N:M.
Sets how many frames to display per number of frames that form one
complete image. Increase the display frame rate to reduce flicker from
your source(s).
Defines the frame order (L-R or R-L) required for 3D perspective. This
option only has meaning when the Frame Rate factor M is equal to 2. For
this case, 2 input frames of data are required to constitute a complete
frame of image data. This parameter tells the system which frames go
together to make a complete image.
When using Line Interleave as the 3D Sync Input Mode, ensure that
Left (L1R1 L2R2) is selected.
Keeps 3D stereo sync output the same as input (true) or reversed
(inverted).
True: 3D L/R sync output from GPO will match L/R sync input.
Inverted: 3D L/R sync output from GPO will be the opposite of sync
input (left = right, right = left).
Creates a blank time interval between left and right frames to allow for
LCD shutter glasses, Z screen, or rotating 3D wheel to synchronize the
output. See Dark Time and Output Delay Notes below. Values between 0
and 65535 are accepted. Tap the Launch Dialog button
the dark time value.
The non-image time in Microseconds (μ). Offset 3D stereo sync output in
relation to dark time interval. Acceptable values are between -32768 and
32767. A positive offset adds a delay and a negative offset starts
playback early. Tap Launch Dialog to enter the output delay value.
The degree of reference between the left and right sync output. Values
between -180 and 180 are accepted. Tap Launch Dialog to enter the
phase delay value.
Description
View 3D Content
to enter
67