Lamp Precautions; Projector Components - Front - Christie cp2215 User Manual

Lamp Precautions

Projector Components - Front

A
B
C
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
Downloaded from ProjectorsManual.com Manuals
• EXPLOSION HAZARD! Wear authorized protective safety gear whenever the lamp door is
open! Never attempt to remove the lamp directly after use. The lamp is under significant
pressure when hot and cold, and may explode, causing personal injury and/or property
damage. Failure to comply results in death or serious injury.
• Any lamp used in the projector is under high pressure and must be handled with great
care at all times. Lamps may explode if dropped or mishandled. Failure to comply results
in death or serious injury.
• Never open the lamp door unless you are wearing protective clothing such as that
included in a Christie Protective Clothing Safety Kit (P/N: 598900-095). Recommended
protective clothing includes, but may not be limited to a polycarbonate face shield,
protective gloves, and a quilted ballistic nylon jacket or a welder's jacket. Christie's
protective clothing recommendations are subject to change. Any local or federal
specifications take precedence over Christie recommendations. Failure to comply results
in death or serious injury.
• Lamp may explode causing bodily harm or death. Always wear protective clothing
whenever lamp door is open or while handling lamp. Make sure those within the vicinity of
the projector are also suited with protective clothing. Never attempt to access the lamp
while the lamp is on. Wait at least 15 minutes after the lamp turns off before powering
down, disconnecting from AC and opening the lamp door. Failure to comply results in
death or serious injury.
Touch Panel Controller (TPC)
A touch-sensitive screen used to control the projector. The TPC can remain mounted on
the projector or it can be wall mounted.
Communications Panel
External devices are connected here.
Adjustable Feet
Turn the adjustable feet to increase or decrease the projector height. See
and Level the Projector on page 5.
Installation and Setup
Adjust Tilt
3