Installation And Setup; Safety Precautions - Christie cp2215 User Manual

Installation and Setup

This manual is intended for professionally trained operators of Christie high-brightness projection
systems. These operators are qualified to replace the lamp and air filter, but should not attempt to
install or service the projector.
Only accredited Christie technicians who are knowledgeable about the hazards associated with
high-voltage, ultraviolet exposure, and the high temperatures generated by the projector lamp are
authorized to assemble, install, and service the projector. In addition, only Christie accredited
personnel are authorized to perform security procedures such as marriage.
This section provides information and procedures for positioning and installing the projector.

Safety Precautions

When installing the projector, observe these important safety rules to avoid personal injury or
damage to the projector:
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
Downloaded from ProjectorsManual.com Manuals
When accessing a restricted access location for projector service or maintenance, avoid
exposure to the projector beam path by making sure to either:
• Turn the projector power off and disconnect the projector from AC power
• Shutter the lamp to avoid emissions from the front aperture
Failure to comply results in death or serious injury.
• Never look directly into the projector lens or at the lamp. The extremely high brightness
can cause permanent eye damage. For protection from ultraviolet radiation, keep all
projector housings intact during operation. Protective safety clothing and safety goggles
are recommended during servicing. Failure to comply could result in death or serious
injury.
• FIRE HAZARD! Keep hands, clothes, and all combustible material away from the
concentrated light beam of the lamp. Failure to comply could result in death or serious
injury.
Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
Failure to comply could result in minor or moderate injury.
This projector must be operated in an environment that meets the operating range
specification. See Operating Environment on page 92.
1