Connect Devices To The Scci Port - Christie cp2215 User Manual

PIN
GPOUT #3
GPOUT #4
GPOUT #5
GPOUT #6
GPOUT #7
PROJ_GOOD
This diagram illustrates how to wire a GPIO cable to a server or a 3D device:
The recommended operating point is 5mA, the maximum current is 50 mA, and the forward voltage
~
drop is 1 V (@ 5 mA).

Connect Devices to the SCCI Port

The Simple Contact Closure Port (SCCI) port is a DB-9 (male) connector located on the PIB input
panel. The SCCI port controls a limited set of projector functionality through contact closures. This
table lists the control functions available through the SCCI port:
PIN Signal Name
1 +5V standby
2 Lamp on
3 +5V standby
4 Lamp off
5 +5V standby
6 Douser closed
7 Douser open
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
Downloaded from ProjectorsManual.com Manuals
Positive Negative
Pin 11 Pin 30
Pin 12 Pin 31
Pin 13 Pin 32
Pin 14 Pin 33
Pin 15 Pin 34
Pin 16 Pin 35
Direction
Current limited 5VDC supply.
Out
In Projector power and lamp is on.
Out Current limited 5VDC supply.
In Projector power on and lamp is off.
Out Current limited 5VDC supply.
In Close douser.
In Open douser.
Installation and Setup
Description
Reserved
Output
Output
Output
Output
Projector Good
Description
13