Table of Contents
Advertisement
26 Chapter 2 Getting started with the CLI
Example
The following is an example of using the help command to see the syntax for
the mshow command.
Logging out of the CLI
To exit a CLI session, type exit at the CLI prompt. The system will notify you
that are logged out of the CLI.
Procedure
1
Example
The following is an example of leaving a CLI session.
Restarting Passport 8250 device using the CLI
Restart the Passport 8250 device using the reboot command.
The syntax of the command is:
where
[net]
the remote host entered in the host inet boot parameter. See NTP 241-5101-
200, Passport 8250 Installation Guide for information on the boot
parameters.
241-5101-201 R2.2
[T1-2]: help mshow
mshow <port#i>[,<port#j>] [-detail]
Terminate the CLI session:
exit
[T1-2]: exit
you have been logged off the CLI.
Info loggin to CLI console is set to on
reboot [net]
restarts the Passport 8250 device and loads the system software from
Note 1: Entering the reboot command without the [net] parameter
restarts the Passport 8250 and loads files from flash memory.
Note 2: After restarting the Passport 8250 device, you can log into the
CLI only after **** REBOOT COMPLETE, SYSTEM READY **** is
displayed.
Advertisement
Table of Contents
