Nokia IPSO 4.0 Reference Manual page 53

c. Use the Proxy interface pull-down menu to select the logical interface from which the
7. Enter the IP address for the local end of the connection in the Local address text box in the
Interface Information table.
You must enter a valid IP address. IPSO does not support dynamically assigned IP addresses
for ISDN interfaces. Do not enter 0.0.0.0.
8. Enter the IP address of the remote end of the connection in the Remote address text box in
the Interface Information table.
9. (Optional) Enter a string comment in the Description text box in the Connection Information
table to describe the purpose of the logical interface, for example, Connection to Sales
Office.
10. Click Outgoing in the Connection Information table.
11. (Optional) Enter the value for the idle timeout in the Idle Time text box in the Connection
Information table.
This time entry defines the time in seconds that an active B-channel can be idle before it is
disconnected. A value of zero indicates that the active B-channel will never disconnect. The
range is 0 to 99999. The default value is 120.
12. (Optional) Enter the value for the minimum call time in the Minimum Call Time text box in
the Connection Information table.
This entry defines the minimum number of seconds a call must be connected before it can be
disconnected by an idle timeout. A value of 0 indicates that the call can be disconnected
immediately upon expiration of the idle timer. If the service provider has a minimum charge
for each call, Nokia recommends the minimum call time be set to this value. The range is 0
to 99999. The default value is 120.
13. Click the 64 Kbps or 56 Kbps radio button in the Rate field in the Connection Information
table to set the data rate for outgoing calls.
14. Enter values for a remote number and subaddress in the Remote Number and (optional)
Remote Sub Number text boxes in the Connection Information table.
15. (Optional) Enter values for a calling number and subaddress in the Calling Number and
Calling Sub Number text boxes in the Connection Information table.
The calling number and subaddress are inserted in a SETUP message when an outgoing call
is made.
Note
The Authentication table entries, which follow, allow the user to manage the parameters
used to authenticate both ends of the communication link.
16. In the To Remote Host section of the Authentication table, in the Name text box, enter the
name that needs to be returned to a remote host when it attempts to authenticate this host.
Nokia Network Voyager for IPSO 4.0 Reference Guide
address for this interface is taken.
53