Table of Contents
Advertisement
9
EBGP Load Balancing Example: Scenario #2
Configuring a Loopback Address on Platform A
1. Configure the interface as in
2. Click Interfaces under Configuration > Interface Configuration in the tree view.
3. Click the Logical Address Loopback link.
4. Enter
Configuring a Loopback Address on Platform B
1. Configure the interface as in
2. Click Interfaces under Configuration > Interface Configuration in the tree view.
3. Click the Logical Address Loopback link.
4. Enter the
Configuring OSPF on Platform A
1. Click OSPF under Configuration > Routing in the tree view.
2. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.1.1; then click Apply.
3. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.2.1; then click Apply
4. Enter
Configuring OSPF on Platform B
1. Click OSPF under Configuration > Routing in the tree view.
2. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.1.2; then click Apply.
3. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.2.2; then click Apply.
4. Enter
Configuring an EBGP Peer on Platform A
1. Configure an EBGP peer on Platform A as in
2. Ente
3. Configure the inbound and route redistribution policies.
4. Click the link for specific peer you configured in Step 1. This action takes you the page that
lets you configure options for that peer.
432
in the New IP Address text box; then click Apply.
1.2.3.4
in the New IP Address text box; then click Apply.
5.6.7.8
in the Add a new stub host column, then click Apply.
1.2.3.4
in the Add a New Stub Host column and then click Apply.
5.6.7.8
as the local address on the main BGP configuration page.
r 1.2.3.4
"Ethernet Interfaces."
"Ethernet Interfaces."
"Ethernet Interfaces."
Nokia Network Voyager for IPSO 4.0 Reference Guide
Advertisement
Table of Contents
Troubleshooting
