Configuring The Internal And External Routers - Nokia IPSO 4.0 Reference Manual

17. Click Save.
18. Configure static routes from this node to the internal and external networks using
192.168.1.5 and 192.168.2.5 as gateway addresses (next hops).
19. On nodes B and C, configure interfaces with real IP addresses in each of the four networks
shown in the example.
20. Join nodes B and C to the cluster.
These nodes will copy the configuration information you entered on node A, including the
static routes to the internal and external networks.

Configuring the Internal and External Routers

You would also need to perform the following tasks on the routers facing the cluster:
1. Because the cluster is using multicast mode with IGMP, configure the internal and external
routers to accept multicast ARP replies for unicast IP addresses. (This is not necessary if you
use forwarding mode.)
2. Configure static routes to the cluster:
Nokia Network Voyager for IPSO 4.0 Reference Guide
On the internal router, configure a static routes for 192.168.2.0 (the external network)
using 192.168.1.10 (the internal cluster IP address) as the gateway address.
On the external router, configure a static route for 192.168.1.0 (the internal network)
using the cluster IP 192.168.2.10 (the external cluster IP address) as the gateway address.
245