Nokia IPSO 4.0 Reference Manual page 343

The new entry appears in the IPSec Transport Rules table.
4. (Optional) To change the policy entry without changing the name of the associated transport
rule, perform the following steps:
a. Click in the blank square next to the current policy entry. Click Apply. The policy name
b. Under the Policy column, select a policy option from the drop-down list and click Apply.
5. From the drop-down list in the Source Filters column, select a filter name that corresponds
to the source of the traffic that will be protected by this policy. Click Apply.
Repeat this operation to add as many filters as necessary.
6. Click Apply after each selection.
Note
Select as source filters only filters that present a single host but no subnet.
Note
If you have 40 or more source or destination filters, they are not displayed as a list on
the Network Voyager page. To view a filter that is not displayed, type the name of the
filter in the appropriate field.
7. From the drop-down list in the Destination Filters column, select a filter name that
corresponds to the destination of the traffic to be protected by this policy.
8. Click Apply and then click Save to make your changes permanent.
9. To delete any entries, check the Delete check box and click Apply.
Click Save to make delete permanent.
Note
Each Network Voyager page displays a maximum of 10 transport rules. If you create more
than 10 rules, they are continued on new pages. Access the new pages by clicking the link
directly below the rule section. The link to more pages appears only after you create more
than 10 transport rules.
Nokia Network Voyager for IPSO 4.0 Reference Guide
is removed.
The new policy is entered without changing the associated transport rule.
343