Nokia IPSO 4.0 Reference Manual page 115

9. (Optional) Change the interface's logical name to a more meaningful one by typing the
preferred name in the Logical name text box.
Click Apply.
10. (Optional) Add a comment to further define the logical interfaces function in the Comments
text box.
Click Apply.
11. To make your changes permanent, click Save.
To change the LMI parameters in frame relay
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to configure in the Physical column. Example:
3. Click the Advanced Frame Relay Options link to go the Frame Relay Advanced Options
page.
The Frame Relay Advanced Options page allows you to configure frame relay protocol and
LMI parameters for this device.
Note
The values you enter are dependent on the settings of the frame relay switch to which
you are connected or to the subscription provided by your service provider.
4. From the Frame Relay Advanced Options page, click Up to return to the Physical Interface
page.
5. Click Save to make your changes permanent.
To change the interface type in frame relay
When connected to a Frame Relay switch or network, the interface type is usually set to DTE.
You may need to change the interface type to DCE if it is connected point-to-point with another
router.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to change in the Physical column. Example:
3. Change DTE or DCE in the Interface type field.
Click Apply.
4. Click Save to make your changes permanent.
Nokia Network Voyager for IPSO 4.0 Reference Guide
ser-s2p1
ser-s2p2.
115