Nokia IPSO 4.0 Reference Manual page 495

Note
To perform the following procedures, use the zap or modzap utility. You can obtain these
utilities from the Nokia Technical Assistance Center (TAC)—refer to Resolution 1261.
If you are using FireWall-1 4.1
1. Set the execute permissions by issuing an
2. To confirm that you have sufficient resources to increase the buffer size, issue the following
command:
# ./modzap -n _fw_logalloc $FWDIR/boot/modules/fwmod.o 0x20000
where
value at the symbol reported.
3. A console message is displayed confirming the change that will take place when you issue
the modzap command in the next step.
You can safely ignore this message.
Note
If the message indicates that you have insufficient resources to accommodate a larger
buffer size, take appropriate actions and try this procedure again. For further
information, contact Nokia Technical Assistance Center (TAC).
4. After you verify that the change is appropriate, issue the same command without the
option:
# ./modzap _fw_logalloc $FWDIR/boot/modules/fwmod.o 0x20000
A confirmation message is displayed, which you can safely ignore.
5. Reboot the system.
If you are using FireWall-1 NG
1. Set the execute permissions by issuing a
2. To confirm that you have sufficient resources to increase the buffer size, issue the following
command:
modzap -n _fw_log_bufsize $FWDIR/boot/modules/fwmod.o 0x200000
where
the value at the symbol reported.
3. A console message is displayed confirming the change that will take place when you issue
the modzap command in the next step.
You can safely ignore this message.
Nokia Network Voyager for IPSO 4.0 Reference Guide
indicates a buffer size of 2MB, and the
0x20000
indicates a buffer size of 2 MB, and the
0x20000
command.
fwstop
option causes
-n
command.
cpstop
option causes
-n
to check the
modzap
-n
to check
modzap
495