Nokia IPSO 4.0 Reference Manual page 454

10
Table 27 ACL Rule Attributes
Attribute
Action
Aggregation Class
Source IP Address
Source Mask Length
Destination IP Address
Destination Mask
Length
Source Port Range
Destination Port Range
Protocol
TCP-Establishment flag
Type of Service (TOS)
for IPv4
Traffic Class for IPv6
454
Description
A rule action can be one of the following six actions:
• Accept—Forward this traffic stream.
• Drop—Silently drop all traffic belonging to this stream.
• Reject—Drop all traffic in this stream and attempt to deliver an ICMP error to the source.
• Skip—Skip this rule proceed to next.
• Shape—Coerce the throughput of this traffic according to a set of parameters given by an
aggregation class.
• Prioritize—Give this traffic stream preferential scheduling on output. When you configure
an ACL rule to use the prioritize action, you must configure an Aggregation Class (AGC).
This link takes you to the Traffic Condition Configuration page, where you can view and
modify existing rate shaping aggregation class configurations on the system. It also allows
you to add new aggregation classes or to delete existing aggregation classes from the
system.
Specifies the source IP address to be used for matching this rule.
Specifies the source filter mask length to be used for matching this rule.
Specifies the destination IP address to be used for matching this rule.
Specifies the destination filter mask length to be used for matching this rule.
Specifies the source port range to be used for matching this rule.
You can specify the Source Port Range only if the selected protocol is either "any," 6, TCP,
17, or UDP.
Specifies the destination port range t
You can specify the Destination Port Range only if the selected protocol is either
"any," 6, TCP, 17, or UDP.
Specifies the IP protocol to be used for matching this rule.
Range: 0-255 or any
Default: Any
When it is selected, traffic matches this rule when it is part of the initial TCP handshake. This
option applies only to IPv4 ACLs.
You can specify the TCP Establishment flag only if the selected protocol is TCP, 6, or "any."
Specifies the type of service to be used for matching this rule.
Range: any or 0x0-0xff
Default: Any
o be used for matching this rule.
Nokia Network Voyager for IPSO 4.0 Reference Guide