Nokia IPSO 4.0 Reference Manual page 74

2
The following figure shows the network configuration for this example.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Select tok-s2p1 in the Physical column of the table.
3. Set the desired value in the Ring Speed column of the Physical configuration table.
Note
This setting must be the same for all hosts on the network to which the device connects.
4. Enter the desired MTU value.
5. In the Allow Source routes (Multi-Ring) field, select On or Off.
6. In the Select Use Broadcast instead of Multicast, select On or Off.
7. Under the Active column of the Logical interfaces table, select On or Off.
8. Click Apply.
Click Up to return to the interface configuration page.
9. Click the logical interface link to configure in the Logical column.
74
FDDI
192.168.1.xxx
Server
Provider
(192.168.2.93)
fddi-s3p1c0
(192.168.1.1/24)
Token Ring
MAU
192.168.3.4
Server
(Optional)
Server
Nokia Network Voyager for IPSO 4.0 Reference Guide
ser-s1p1c0 (192.168.2.1)
Nokia Platform A
tok-s2p1c0 (192.168.3.2)
192.168.3.5
Server
(Optional)
tok-s1p1c0 (192.168.3.1)
Nokia Platform B
eth-s2p1c0 (192.168.4.1/24)
192.168.4.xxx
Server
00038