Nokia IPSO 4.0 Reference Manual page 422

9
To configure an IBGP peer for Nokia Platform B
1. Enter
2. Click Internal in the Peer Group type drop-down list; then click Apply.
3. Enter
To set the local preference value for an IBGP peer
1. Click Up to take you back to the main Config page for Network Voyager.
Click the Inbound Route Filters link in the Routing Configuration section.
2. Click Based on Autonomous System Number.
3. Enter
4. Enter
5. Enter
6. Click Apply.
7. Click Accept in the All Routes from BGP AS 100 field; then click Apply.
To configure the static routes required for an IBGP session
1. Click Static Routes under Configuration > Routing Configuration in the tree view.
2. Enter
3. Enter
4. Enter
To configure the static routes required for Nokia Platform B
1. Configure the interface as in
1. Click BGP under Configuration > Routing Configuration in the tree view.
2. Enter
3. Enter
4. Enter
5. Click Top button at the top of the configuration page.
6. Click the Static Routes link in the Routing Configuration section.
7. Enter
8. Enter
9. Enter
422
in the Peer Autonomous System Number text box.
100
in the Add Remote Peer IP Address text box; then click Apply.
20.10.10.2
(or any unique number in the range of 512 to 1024) in the Import ID text box.
512
in the AS text box.
100
in the LocalPref text box.
200
in the New static route text box.
10.10.10.0
in the Mask length text box.
24
in the Gateway text box; then click Apply.
20.10.10.2
"Ethernet Interfaces."
in the Router ID text box.
20.10.10.2
in the AS number text box.
100
in the Add remote peer ip address text box, then click Apply.
20.10.10.1
in the New Static Route text box.
10.10.10.0
in the Mask Length text box.
24
in the Gateway text box; then click Apply.
20.10.10.1
Nokia Network Voyager for IPSO 4.0 Reference Guide