Nokia IPSO 4.0 Reference Manual page 451

To create or delete an ACL
1. Depending on whether you are using IPv4 or IPv6, click the following link.
a. For IPv4 ACLs, click Access List under Configuration > Traffic Management in the tree
b. For IPv6 ACLs, click IPv6 Access List under Configuration > IPv6
2. To create an ACL, enter a name for the ACL in the Create a New Access List edit box and
click Apply.
The Access Control List name, Delete check box, and Bypass this Access List field appear.
3. To delete an ACL, select Delete next to the Access Control List you want to delete and click
Apply.
The Access Control List name disappears from the Access List Configuration page.
4. Click Save to make your changes permanent.
To apply or remove an ACL to or from an interface
1. Depending on whether you are using IPv4 or IPv6, click the following link.
a. For IPv4 ACLs, click Access List under Configuration > Traffic Management in the tree
b. For IPv6 ACLs, click IPv6 Access List under Configuration > IPv6
2. Click the link for the appropriate ACL in the ACL Name field.
The page for that ACL appears.
3. To apply an interface to the ACL:
a. Select the appropriate interface from the Add Interfaces drop-down window.
b. Select either Input or Output from the Direction drop-down window.
Note
Only the default rule appears in the Access Control List until you create your own rule.
c. Click Apply.
Nokia Network Voyager for IPSO 4.0 Reference Guide
view.
Configuration > Traffic Management in the tree view.
view.
Configuration > Traffic Management in the tree view.
You can apply to an interface the same direction to both an IPv4 and an IPv6 ACL.
However, you cannot apply to an interface the same direction to more than one IPv4
ACL, or to more than one IPv6 ACL.
Selecting the "input" direction for a ACL with a rule whose action is set to "prioritize" is
equivalent to setting the action to "skip."
The new interface appears in the Selected Interfaces section.
451