Table of Contents
Advertisement
9
Aliased Interfaces
When an interface has multiple addresses configured, each address is treated as a distinct
interface since it represents a logical subnet. Such a configuration implies that an update is sent
for each IGRP-configured address. In the configuration syntax, you can specify a particular
address of an interface on which to run IGRP as opposed to the complete interface (all addresses
of the interface).
IGRP Aggregation
Most routing aggregation occurs only if explicitly configured; therefore, it is worth noting some
of the implicit aggregation that occurs in IGRP. By definition, no mask information is included
in the IGRP route entry. System and exterior routes have an implied mask of the natural classful
mask. Interior routes are propagated from one interface to another only if the two interfaces are
subnetted from the same IP class address and have the same subnet mask. Otherwise, an interior
route is converted (an aggregation occurs) to a system route. Any supernetted routes
redistributed into IGRP are ignored. In sum, any route redistributed into IGRP that is marked as
a system or exterior route has the natural class mask applied to the route to determine what route
should be advertised in an update.
Configuring IGRP
Note
IGRP configuration of an interface is available only if you are licensed for IGRP on your IP
router. (See the
1. Complete
2. Click IGRP under Configuration > Routing Configuration in the tree view.
3. Enter the AS number in the Autonomous System Number text box.
4. Click on for each interface to configure; then click Apply.
5. (Optional) Enter a new delay metric in the Delay text box for each interface (for example,
100 for 10 Mbps Ethernet); then click Apply.
The delay is measured in units of 10 microseconds.
6. (Optional) Enter a new bandwidth metric in the Bandwidth text box for each interface (for
example, 1000 for 10Mbps Ethernet); then click Apply.
The bandwidth is entered in bits per second scaled by a factor of 10,000,000 (10,000,000/x
Kbps), where x is the actual bandwidth of the interface.
7. (Optional) In the Protocol section, enter a new bandwidth multiplier in the K1 (bandwidth
multiplier) text box; then click Apply.
K1 is used to globally influence bandwidth over delay.
388
Licenses
link on the Configuration page.)
"Ethernet Interfaces"
for the interface.
Nokia Network Voyager for IPSO 4.0 Reference Guide
Advertisement
Table of Contents
Troubleshooting
