Nokia IPSO 4.0 Reference Manual page 364

9
2. (Optional) Change any configuration parameters for the interface, then click Apply.
Note
The hello interval, dead interval, and authentication method must be the same for all
routers on the link.
3. To make your changes permanent, click Save.
Configuring OSPF Example
This example consists of the following:
Enabling OSPF with backbone area (Area 0) on one interface
Enabling OSPF on Area 1 on another interface
Summarizing and aggregating the 192.168.24.0/24 network from Area 0 to Area 1
In the following diagram:
Nokia Platform A and Nokia Platform D are gateways.
Nokia Platform C is an area border router with Interface e1 on the backbone area (Area 0),
and Interface e2 on Area 1.
Nokia Platform A and Nokia Platform B are on the backbone area.
Nokia Platform D is on Area 1.
The routes in Area 0 are learned by Nokia Platform D when the ABR (Nokia Platform C) injects
summary link state advertisements (LSAs) into Area 1.
1. Configure the interfaces as in
2. Initiate a Network Voyager session to Nokia Platform C.
3. Click OSPF under Configuration > Routing Configuration in the tree view.
4. Click the backbone area in the drop-down list for e1; then click Apply.
364
24.58/30
24.57/30
24.46/30
24.49/30
Nokia
Platform B
24.45/30
Nokia
Platform A
"Ethernet Interfaces."
Nokia Network Voyager for IPSO 4.0 Reference Guide
Area 0
Nokia
Platform C
24.50/30 24.53/30
e1 e2
Nokia
Platform D
Area 1
24.54/30
e3
00340