HP DesignJet 2500CP Service Manual page 69

Message Explanation and Action
Calibration done Accuracy calibration is complete.
Continue
Press
Cancelled You have just cancelled the last print or function.
Continue
Press
Check JJ-J
The printer has detected an error in the printhead cleaners indicated by the stars.
Close right door
Reseat (do not replace) the indicated cleaners. When you have done so, close the
right door of the printer.
Check ink The printer has detected an error in the cartridges indicated by the empty squares.
cartridges
Reseat (do not replace) the indicated cartridges or press the
JJ-J Abort
the procedure. In that case, you will not be able to print, and you may later
resume checking the ink system by pressing the Replace Ink System button.
Check ink system After an error has been detected in the ink system, you are given the chance to
Ignore check it.
Press
systems are affected.
Press
cannot be assured.
Check printheads The printer has detected an error in the printheads indicated by the empty
JJ-J Abort
squares. The printhead can be replaced, but you should replace all components of
the failing ink systems as soon as possible.
Reseat (do not replace) the indicated printheads or press the
the procedure. In that case, you will not be able to print, and you may later
resume checking the ink system by pressing the Replace Ink System button.
Close left door to You opened the left door while the printer was busy, or you have finished
continue installing the ink cartridges.
Close the left door to continue.
Close roll cover Rewind the media to take up any slack in the roll, close the roll cover, then press
Continue to continue.
Close window to You have finished installing the printheads.
continue
Close the window to continue.
Create pattern Press
Measure pattern Press
Disk error (HP DesignJet 2500CP/3500CP only) An error on the hard disk has been detected.
Continue
Press
User Messages
to continue.
to continue.
to check the ink system right now. The printer will indicate which ink
to ignore the error and continue printing. In this case the image quality
to create the pattern for automatic calibration.
to measure the pattern for automatic calibration.
to continue.
HP DesignJet CP Series Printers
key to terminate
key to terminate
3-3