System Error: 020006; System Error: 020010 - HP DesignJet 2500CP Service Manual

System Error:
Problem Description: The refill position in the Y axis is not calibrated.
Corrective Action:
System Error:
Problem Description: Problem with fine movement of the Y axis motor.
Corrective Action:
System Error Codes
020006
Perform the Refill Calibration ' Page 5 8.
020010
Try the following:
D Switch the printer OFF and ON again and
check if the error code disappears. If the error
code disappears, do NOT try to troubleshoot
any further.
D Check that the Encoder Strip is NOT damaged
or dirty. If necessary, clean the encoder strip, or
if damaged, replace the Encoder Strip '
Page 8 32.
D Clean and lubricate the slider rods.
D Replace the Y axis Motor Assembly ' Page 8 45.
D Replace the Tensioner Holder Assembly (with
spring) ' Page 8 39.
D Replace the Y axis belt ' Page 8 39.
D Replace the Carriage Assembly ' page 8 42.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
HP DesignJet CP Series Printers 2-25