HP DesignJet 2500CP Service Manual page 84

Message Explanation and Action
STATUS The printer is ready to print.
Ready
Send a file to the printer.
STATUS The printer is ready for you to load media.
Ready for media
Load appropriate media.
STATUS The printer has received data.
Receiving
Wait for further messages.
STATUS The printer is recovering the printheads after an ink system replacement process
Recovering printhds. (only for UV Pigmented inks), or you have initiated the printhead recovery
procedure under Utilities / Service Tests/ Recover Printheads.
Wait for the printhead recovery procedure to complete.
STATUS The printer is filling the printheads.
revision levels A.02.08 or higher.)
Refilling X m XX s
Wait for the process to complete.
STATUS The ink system replacement process has been cancelled, and the printhead carriage is
Returning printheads returning to its station at the right of the printer.
Wait until the carriage is in position.
STATUS The printer is trimming the edge of roll media.
Roll feed edge trim
Wait until the media has been trimmed.
STATUS Nesting is turned on. The printer is waiting for another print to nest.
Waiting nest
Send the printer another file for printing.
3-18
HP DesignJet CP Series Printers
(This message only applies to firmware
User Messages