System Error: 010036 - HP DesignJet 2500CP Service Manual

System Error:
Problem Description: ADC Test Failure in the Main PCA.
Corrective Action:
2-10
D If the Error is related to the Refill Stepper Motor
then replace the Refill Assembly ' Page 8 55.
D If the Error is related to the Primer Stepper Motor
then replace the Primer Assembly ' Page 8 29.
D If the Error is related to the Service Station
Stepper Motors then replace the Service Station
Assembly ' Page 8 26.
D If the Error is related to the Bail Stepper Motor
then replace the Bail Stepper Motor Assembly '
Page 8 62.
D Replace the Electronics Module ' page 8 6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
010036 (see next page for 010036 0000XX00)
Try the following:
D Switch the Printer OFF from the back and then
disconnect the Trailing Cable from the
Electronics Module. Switch the Printer ON and
see if the Error Code now changes to 010037".
If the error code remains as 010036", replace
the Electronics Module ' page 8 6.
D If the Error Code changes to 010037" then try
the following:
S Make sure that the Trailing Cable is
connected correctly.
S Replace the Trailing Cable ' page 8 36.
S Replace the Carriage Assembly ' page 8 42.
S Replace the Electronics Module ' page 8 6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
HP DesignJet CP Series Printers
System Error Codes