Y Axis Motor Assembly; Removal - HP DesignJet 2500CP Service Manual

Y Axis Motor Assembly

Refer to figure 16 ' page 8 47

Removal

Switch off the printer and remove the power cord.
1. Remove the following:
1. Window and Top Cover ' page 8 15.
2. Right Hand Cover ' page 8 21.
3. Left Hand Cover ' page 8 18.
4. Encoder Strip ' page 8 32.
5. Y Axis belt ' page 8 39
2. Remove the cables from the cable clamps (item 1) on the Y axis bracket
(item 2).
3. Remove two T 15 screws and washers installed into the Y axis bracket
(item 3).
4. Remove the one remaining T 20 screw (item 4) which secures the Y axis
Motor assembly (item 6) to the front slider rod (the other screw was
removed when you removed the encoder strip).
5. Disconnect the Y axis motor cable (item 5) from the position J2 Y
MOTOR on the refill interconnect PCA (item 7).
6. Remove the Y axis motor assembly from the slider rods.
8-45
WARNING
HP DesignJet CP Series Printers
Removal and Installation