Elevator Assembly; Removal - HP DesignJet 2500CP Service Manual

Elevator Assembly

Refer to figure 18 ' page 8 54

Removal

Switch off the printer and remove the power cord.
1. Remove the ink delivery system (Refer to the User Guide).
2. Remove the following:
1. Window and Top Cover ' page 8 15.
2. Left Hand Cover ' page 8 18.
Note: To gain access to the screws securing the elevator
assembly to the left hand side chassis, it may be necessary to
manually raise the elevator assembly. This can be done by
turning the motor gear under the elevator assembly.
3. Remove the T 20 screw (item 1) located at the bottom rear of the elevator
assembly.
4. Loosen the three T 20 screws (item 2) securing the elevator assembly to
the left hand side chassis.
5. Remove the top half of the elevator assembly (item 3) by releasing it from
two retaining clips at the back, then lifting up and to the left.
6. Disconnect the platform sensor cable from position J5 PLATEF
SENSOR on the refill interconnect PCA and release from the cable
clamp.
7. Disconnect the elevator stepper motor cable from position J9 ELEV
STEPPER on the refill interconnect PCA and release from the cable
clamp.
8. Remove the elevator assembly by sliding it up and pulling it towards you.
8-52
HP DesignJet CP Series Printers
WARNING
Removal and Installation