System Error: 040601; System Error: 050000 - HP DesignJet 2500CP Service Manual

System Error:
Problem Description: The MIO card does not support the MIO 6 protocol.
Corrective Action:
System Error:
Problem Description: The Line Sensor has problems finding the Mark
Corrective Action:
System Error Codes
040601
Cards with version 5 or below can not be used with
this plotter. Version 5.1 cards behave as expected
but do not support PML instructions. Install the
latest version.
Install the latest version of the MIO Card.
050000
Encoder.
Try the following:
D Clean the Mark Encoder if necessary.
D Make sure the Line Sensor is installed and
connected correctly.
D Perform the Service Accuracy Calibration '
Page 5 16.
D Replace the lens cover which is installed on the
line sensor.
D Replace the Trailing Cable ' Page 8 36.
D Replace the Carriage Assembly ' Page 8 42.
D Replace the Electronics Module ' page 8 6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
HP DesignJet CP Series Printers 2-27