System Error: 010024; System Error: 010030; System Error: 010031 - HP DesignJet 2500CP Service Manual

System Error:
Problem Description: A fuse on the Main PCA has blown.
Corrective Action:
System Error:
Problem Description: Problem initializing the encoder pulse generator.
Corrective Action:
System Error:
Problem Description: One of the two interconnect boards not detected.
Corrective Action:
System Error Codes
010023
Try the following:
D Check the X encoder and optical sensors cable
path for damage. If the cables are damaged,
they could cause the fuses in the new
electronics module to also blow.
D Replace the Electronics Module ' page 8 6.
010024
Replace the Electronics Module ' page 8 6.
010030
Try the following:
D Make sure that the Interconnect Cables (the
two black cables that connect the Refill
Assembly and the Service Station Assembly to
the Electronics Module) are correctly connected
to the Electronics Module.
D Replace the interconnect cables:
S Service Station Interconnect
Cable ' Page 8 87.
S Refill Interconnect Cable ' Page 8 87.
D Replace the Refill Interconnect PCA ' page 8 64.
D Replace the Service Station Assembly ' page 8 26.
D Replace the Electronics Module ' page 8 6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
HP DesignJet CP Series Printers 2-5