HP DesignJet 2500CP Service Manual page 80

Message Explanation and Action
Roll empty You have used all of the media roll.
Load new roll
Load a new roll of media.
Roll misaligned Roll media is skewed.
Reload roll
Reload media.
Yes
Set transport You have selected transport mode in the front–panel menu. The printer is waiting
Νο
Mode for you to accept or reject the transport mode. Accepting transport mode starts
the process of removing all ink systems.
Press
Sheet load Press
Roll load Press
Sheet misaligned Sheet media is skewed.
Reload sheet
Remove it and reload it so that the left and right edges being loaded into the
printer are square. The leading edge must also be straight.
Sheet required You have started an accuracy calibration check but media is not present.
for calibration
Load media.
Sheet / Roll? Either: Sheet mode was chosen while loading roll media.
Reload media
Reload media.
Or: a sheet more than 51 inches (130 cm) long was loaded.
Trim the sheet and reload.
Switch power off You have selected the transport mode shut-down sequence. The printer is waiting
for you to turn the power switch, on the rear of the printer, to OFF.
Switch OFF the printer.
Switch power off The printer may be jammed with media.
Check paper path
Turn OFF the printer. Check the media path and clear it if necessary. Then turn
on the printer.
Switch power off The printhead carriage cannot move. The printer may be jammed with media.
Check printhead
Turn OFF the printer. Check the media path and clear it if necessary. Then turn
path
ON the printer.
System Error The ambient light level in the area of your printer is too bright and is causing the
060000 optical sensor in your printer to malfunction.
Reduce the ambient light level or move the printer to a location where the light
level is lower.
3-14
HP DesignJet CP Series Printers
to accept or press to reject.
to load sheet media.
to load roll media.
User Messages