Left Hand Cover And Left Hand Trim Assembly; Removal - HP DesignJet 2500CP Service Manual

Left Hand Cover and Left Hand Trim Assembly

Refer to figure 5 ' page 8 20

Removal

1. Remove the ink delivery system (Refer to the User Guide).
Switch off the printer and remove the power cord.
2. Remove the following:
1. Window and Top Cover ' page 8 15.
3. Open the door on the left hand cover (item 1).
4. Remove the left hand trim assembly (item 2) by removing four T 15
screws (item 3) and one T 20 screw (item 4) and disconnecting the cover
sensor (item 5).
Be careful not to drop the cover once the securing fasteners
have been removed. Support the cover throughout the next step.
5. Remove the three T 15 screws (item 6) securing the cover to the left hand
side chassis.
6. Making sure the left hand door is open, remove the left hand cover
(item 7).
Note: To remove the Cover Sensor, disconnect it from position
J6 DOOR SW on the Refill Interconnect PCA.
8-18
HP DesignJet CP Series Printers
WARNING
Removal and Installation