D10. Cutter
The purpose of this test is to verify the operation of the Cutter Assembly.
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE
REPLACING THE CUTTER ASSEMBLY. IF THIS TEST PASSES, DO
NOT REPLACE THE CUTTER ASSEMBLY.
Perform the Cutter test as follows:
1 In the Diagnostics submenu, scroll to D10 Cutter" and press Enter.
Diagnostics
D10 Cutter
2 While the test is being performed, a row of ***" will be displayed on the
front panel. During the test, the Carriage picks up the cutter and runs it
along the length of the printer twice.
3 Once the test is completed, the D1000 Done" message is displayed on the
front panel.
If the carriage picks up the Cutter Assembly and runs it along the
length of the printer twice, then the test has passed.
IF THIS TEST PASSES, DO NOT REPLACE THE CUTTER
If the carriage does not pick up the Cutter Assembly then the test has
failed. To resolve the problem, try one of the following:
1 Check if the Cutter has been disabled through the front panel (Device
Setup / Cutter).
2 Perform the Carriage test ' page 4 11.
3 Replace the Cutter Assembly ' page 8 48.
4-22
ASSEMBLY.
HP DesignJet CP Series Printers
Service Tests