Installation - HP DesignJet 2500CP Service Manual

Table of Contents

Advertisement

Installation

1. Install the refill assembly (item 7) in the correct position between the
Y axis bracket (item 6) and the left hand side chassis.
2. Install the refill assembly onto the three T 15 screws (item 4) and secure
the refill assembly to the left hand side chassis.
3. Install the T 15 screw (item 5) securing the refill assembly to the Y axis
bracket.
4. Connect the following cables to the refill interconnect PCA (item 1):
1. Valve sensor cable in position J4 VALVE SENSOR
2. Door Sensor cable in position J6 DOOR SW
3. Refill Sensor cable in position J3 REFILL SENSOR
5. Install the door sensor cable and the refill sensor cable into two cable
clamps (item 2) on the left hand side chassis.
6. Connect the stepper motor cable (item 3) to the stepper motor.
7. Use a cable clamp to clamp the valve sensor cable and the refill stepper
motor cable to the Y axis bracket (item 6).
8. Install the following:
1. Window and Top Cover page ' 8 15.
9. Connect the power cord and turn the printer on in service mode
10.Perform C02 Refill Service Calibration page ' 5 8 .
11. Perform D06 Refill Service Test 4 16
12. Install the following:
1. Left Hand Cover ' page 8 18.
8-56
HP DesignJet CP Series Printers
Removal and Installation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designjet 3500cpDesignjet 2000cpDesignjet 3000cp

Table of Contents