System Error: 020011; System Error: 040Xxx - HP DesignJet 2500CP Service Manual

System Error:
Problem Description: Error during initialization of the Y axis.
Corrective Action:
System Error:
Problem Description: MIO Card Error
Corrective Action:
2-26
020011
Try the following:
D Switch the printer OFF and ON again and
check if the error code disappears. If the error
code disappears, do NOT try to troubleshoot
any further.
D Check that the Encoder Strip is NOT damaged
or dirty. If necessary, clean the encoder strip, or
if damaged, replace the Encoder Strip '
Page 8 32.
D Clean and lubricate the slider rods.
D Replace the Y axis Motor Assembly ' Page 8 45.
D Replace the Tensioner Holder Assembly (with
spring) ' Page 8 39.
D Replace the Y axis belt ' Page 8 39.
D Replace the Carriage Assembly ' page 8 42.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
040xxx
Try the following:
D Press ENTER and switch the printer OFF . Make
sure the MIO card is installed correctly and
switch the printer ON again. If this error code
continues to appear then replace the MIO Card.
D If the system error continues to appear after
replacing the MIO card, then replace the
Electronics Module ' page 8 6.
HP DesignJet CP Series Printers
System Error Codes