HP DesignJet 2500CP Service Manual page 83

Message Explanation and Action
STATUS The lens cover on the printhead carriage requires maintenance.
Lens maintenance
Press the
Spare lens covers are inside the right door.
STATUS The printer is loading roll media.
Loading roll
Wait for the loading to complete.
STATUS The printer is loading sheet media.
Loading sheet
Wait for the loading to complete.
STATUS One or more of the four ink systems are out of ink.
Low on ink
Press the
print showed any degradation in image quality. If there is still a large amount of
ink remaining in the ink cartridges, see the message Printhead failure.
STATUS The printer is being used more intensively than the recommended duty cycle.
Maintenance advised
Refer to Chapter 9 to perform the Preventive Maintenance.
STATUS The printer is measuring the accuracy calibration print that you just loaded.
Measuring pattern
Wait for the calibration to complete.
STATUS The printer has received a file, is ready to print, but has no media loaded.
Out of media
Load appropriate media.
STATUS You have pressed the
action. The printer will pause when it has completed its current action.
Pause pending
Wait for the current action to complete.
STATUS You have pressed the
Paused the Pause key again.
Press the Pause key again when you are ready.
STATUS The printer is printing.
Printing
Wait for the printing to complete.
STATUS The printer is printing with a special print mode controlled by your software rather
Printing (Special) than by the printer.
Wait for the printing to complete.
STATUS The printer has received a file from your software and is processing it ready to print.
Processing
Wait for the printing to complete.
User Messages
Replace Ink System key to replace the lens cover with a new one.
Replace Ink System key to replace the ink systems affected, if the last
Pause key but the printer was busy performing a previous
Pause key. The printer will remain paused until you press
HP DesignJet CP Series Printers
3-17